Logo

U3635 Engine Code Repair

Meaning of U3635 engine trouble code is a kind of network trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

U3635 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for U3635 code is occuring now you should check U3635 repair processes.
Now don't ask yourself; What should you do with U3635 code ?
The solution is here :

U3635 Possible Solution:

U3635 Engine

Air Conditioning Pressure Sensor (ACP) Insufficient Pressure Change Each time the A/C clutch engages, the PCM is looking for a pressure change in the refrigerant. If the change in pressure is outside of the calibration the DTC will set. A/C system mechanical failure Open ACP or VREF circuit A/C sensor damaged A/C system electrical failure A/C clutch always engaged Verify A/C system function, including refrigerant charge.

U3635 Code Meaning :

U
OBD-II Diagnostic Network (U) Trouble Code For Engine

3
Ignition System Or Misfire

6
Fuel Composition Sensor Circuit Malfunction

3
Turbocharger Boost Sensor A Circuit Low

5
Timing Reference High Resolution Signal A Too Many Pulses

Regarding the U3635 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

U3635 OBD-II Diagnostic Network (U) Trouble Code Description

U3635 engine trouble code is about Timing Reference High Resolution Signal A Too Many Pulses.

Main reason For U3635 Code

The reason of U3635 OBD-II Engine Trouble Code is Fuel Composition Sensor Circuit Malfunction.

U3635 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.